Upgrade Horn 6 to 7
...

Upgrade Horn 6 to 7

Upgrade Horn 6 to 7

Would you also like to benefit from the numerous advantages of the latest EISENHORN Generation 7 power station? With this upgrade, you can easily upgrade your EISENHORN 6 to the latest Generation 7 without having to buy a completely new fitness station (please note the installation instructions at the bottom of the description).

After your upgrade you will benefit from…

  • A fantastically smooth training feeling – the training feeling with a EISENHORN has never been better. The pressure ratio on the thinner piston pin results in even better gliding behavior and therefore a better training feel. Best of all: the tooth surfaces no longer need to be lubricated.

  • Train even more efficiently – With the EISENHORN 7 you benefit from even finer weight adjustment. We have halved the intermediate levels so that you can train even more efficiently.

  • Less wear and tear thanks to innovative design – With the EISENHORN 7, you won’t find a restraining rope. Thanks to further technical development, the horn is held securely and stably in position without a retaining rope. This means that you no longer need to install or replace a restraining rope.

  • Maximum stability – Benefit from an even more harmonious and robust motion sequence thanks to the 10 mm thick tooth plates and the wider bearing points.

  • Maximum safety – after the upgrade, the horn is no longer under tension in the park position (no restraining rope). This means you can store your EISENHORN more safely than ever after your training session.

5-7 working days ex works
€ 299,00
inclusive of VAT

You can easily install the upgrade from your EISENHORN 6 to Generation 7. To do this, proceed as follows:

  • Unscrew your existing EISENHORN 6 carriage from your column using the rotary knob.

  • Place your sledge (incl. horn and piston) on a scratch-free surface.

  • Follow the individual steps in the enclosed instructions to install your upgrade

  • The new “Magic retention function” allows you to move your horn with slight pressure over a small resistance – exactly at the point where your horn meets the stop pin. In future, you will feel a slight resistance every time you switch between the parking and training position.

  • For the upgrade, you also need to replace the bolt on the piston – two suitable bolts are already included in the scope of delivery. As the pin is secured with Loctite, a vice is helpful and necessary for the replacement. You will find all the information on the procedure in the detailed instructions.

  • Tip: You can loosen your piston pin more easily by using a hot air dryer. To do this, point the hot air gun directly at the piston pin at the highest temperature setting for about 3 minutes and at a short distance. You can then loosen the pin with a ring wrench and replace it. As the heated piston pin is hot, please do not touch it without protective clothing.

Please note that this upgrade is only compatible with generation 6. Earlier EISENHORN generations are not compatible with this upgrade.